According to the surface area, stainless steel wire mesh corrugated fillers can be divided into 250 (ax) type, 500 (bx) type, and 700 (cy) type. At present, the production and processing of packaging and standardization are combined with machinery and manual work, and each process and step requires strict quality control. In order to ensure the quality of stainless steel wire mesh corrugated fillers, let's take a brief introduction to some relevant knowledge about its production.

Cutting stainless steel wire mesh corrugated packing is a preliminary preparation for processing wire mesh corrugated packing. Not only should the required height be matched with the width of the cut stainless steel wire mesh corrugated filler, but also the shrinkage coefficient of the hydraulic mesh belt should be considered, which varies according to the material of the stainless steel wire mesh corrugated filler. The direction of cutting is usually at a specific angle to the meridian, which mainly depends on the strength of the metal mesh belt, and the cutting line must be straight. Then spot weld the cut stainless steel wire mesh corrugated filler into long strips, and then punch them as needed and required.

Before installing the stainless steel wire mesh corrugated packing, the specific number of corrugated corrugated materials in the diameter direction should be calculated based on the diameter of the tower and the wave height of the wire mesh belt. Then, according to the curvature requirements of the tower diameter, the length of each piece of stainless steel wire mesh corrugated packing should be calculated. Then, the material should be cut to obtain each piece of wire mesh and assembled according to the arc. During assembly, each piece must be kept straight, After assembling the stainless steel wire mesh corrugated filler, tie it tightly along the arc edge with wire mesh tape and weld it into a whole.